DIY Projects

Gas and pollutant detector kit. MQ-2 MQ-3 MQ-4 MQ-5 MQ-6 MQ-7 MQ-8 MQ-9 MQ135

9pcs mq2 mq 3 mq 4 mq 5 mq 6 mq 7 mq 8 mq 9 mq 135 module de capteur de gaz

MQ sensors are physicochemical sensors for detecting a wide variety of gases, pollutants and fumes in the atmosphere . This table lists the main technical information and refers to the technical documentation as well as the calibration instructions found on the internet.

Note. Before operating and delivering a correct measurement, some sensors must be preheated. This is the case for example of MQ-131, MQ-135, MQ-137 which require 24 hours of preheating. The MQ-137 even takes 48 hours.

Warning, do not use this detector for applications that may endanger the safety of people (medical, industrial applications, etc.)

Warning. The sensor heats up after a few minutes of use. This is normal, it is the very principle of operation of all physicochemical sensors. Take this into account when designing your project.

Sensor Sensitive to Preheating * Technical documentation Calibration Example
MQ-2 Methane, Butane, LPG and fumes 48h Read Read
MQ-3 Alcohol, Ethanol and fumes 24h Read Read the article of nootropicdesign (English)
MQ-4 Methane (CH4). From 300 to 10,000 ppm 48h  Read
MQ-5 Natural gas, LPG. From 300 to 50,000 ppm. Response time less than 10s 24h  Read
MQ-6 LPG, butane. From 200 to 10,000 ppm 48  Read
MQ-7 Carbon monoxide (CO). From 20 to 2000 ppm 48h  Read
MQ-8 Hydrogen. From 100 to 10,000 ppm 24h  Read
MQ-9 Carbon monoxide, methane (CH4)  Read  Read the seeedstudio article
MQ131 Ozone  Read
MQ135 Air quality 24h  Read Read
MQ136  Gaseous hydrogen sulfide (H2S). From 1 to 1000 ppm 24h  Read
MQ137 Ammonia. From 5 to 500ppm  Read
MQ138 Benzene, Toluene, Alcohol, Acetone, Propane, Formaldehyde, Hydrogen. From 10 to 1000ppm except for NH3, from 10 to 3000 ppm  24h  Read
MQ214 Methane (from 3000ppm to 20000ppm), LPG and propane (500ppm to 10000ppm, butane (500ppm to 10000ppm)  24h  Read
MQ216 Natural gas, coal gas, Propane, CH4  24h Read
MQ303A Alcohol, Ethanol, fumes  + 48h Read Read
MQ306A LPG, butane

Same as MQ-6 but with lower heating voltage (0.9V)

 + 48h Read
MQ307A Carbon monoxide (CO)

Identical to MQ-7 but with a voltage varying from 0.2 to 0.9V

 + 48h  Read
MQ309A Carbon monoxide, flammable gases

Identical to MQ-9 but with a voltage varying from 0.2 to 0.9V

 + 48h Read

MQx series pollutant sensor kit for Arduino, ESP32, ESP8266, Raspberry Pi projects

€17.65
in stock
as of 22 June 2021 3 h 02 min
Amazon.com
Click to rate this post!
[Total: 0 Average: 0]
Exit mobile version